General Chat > Classifieds

Advice on posting original art

(1/3) > >>

Huey2:
Hi all,
I was wondering if any of you could offer some advice on the best way to post comic artwork so that it doesn't get damaged. Any help would be much appreciated.

Jim_Campbell:
Flat, not rolled. Sandwiched between the stiffest, heaviest cardboard you can lay your hands on. Use a a service like ‘Signed For’ from Royal Mail, but check what insurance cover is offered — try to get cover to match the value if your art, so you can at least refund the recipient and then get your own money back from the insurance if the worst happens.

Barrington Boots:
I've never posted original art but I've had a few delivered in the post. 100% what Jim says, and try and get it into a plastic envelope before you sandwich it between the card. You want it too stiff to bend and thick enough to withstand getting wet.
I had a very expensive bit of art delivered and I was nervous as anything about anything happening to it - the seller used DPD so we could track it's progress online which went a long way towards easing both our jitters.

Lorenzo:
Interesting choice Jim. I'd be interested in your dislike for tubes.
If I send anything that absolutely must not get damaged (no finger marks or corner dents) I would always choose a thick walled tube. *Very* loosely rolled. Just make sure the art is covered in acid free tissue paper, front and back, with no chance for the art to shift length ways in the tube (foam or polystyrene plug).
If you want to send art on Bristol board or art that can't be rolled for any reason (painted, heavy paper sort), then I mount it between two sheets of hardboard/thick card like Jim said, but then boxed with at least 1cm space (foam/bubblewrap/chip filled) on all sides. No matter how thick the card is, if it gets bent your art is fugged. Air space surround is essential. Always make sure your backing boards are bigger than the art (not the exact same size) and make sure it can't shift so a corner wont stick out.
The amount of effort is of course dependant on how valuable you think it is!

Jim_Campbell:

--- Quote from: Lorenzo on 01 September, 2021, 09:10:31 AM ---I'd be interested in your dislike for tubes.

--- End quote ---

Original art can crack when rolled. Painted, obviously, but also B&W. I learned this back when I drew for a couple of small press titles in the late 80s/early 90s — I sent in my first completed pages rolled up in a tube and got a telling off — the surface of the paper can crack and create little spiderwebs of white lines in any areas of solid black.

Sketches/commissions on cartridge/layout paper are probably OK to roll but any paper stock heavier than that… definitely flat, IMO.

Navigation

[0] Message Index

[#] Next page

Go to full version